R. Patel

Posted on: January 26th, 2015 by Kellie

Our roof if now complete. As you know this was a two year project. We have a 25,000 ft roof with numerous other coatings on it. 25% built up with at least 4 coats of elastomeric and 25% metal with a Dicor product that we kept reapplying and the other 50% original metal. We tackled the first two parts using your proflex primer and then the liquid epdm rubber. After two years it passed with flying colors we did the job ourselves so I am sure it took longer than it needed but we were extremely relieved and a little surprised that the roof did not leak the first winter after application. Normally that is when we encounter our leaks due to the expansion and contraction of the metal against the coatings. You sales manager will remember me for sure because I was highly skeptical with yet another product claiming to end all roof leaks and also that yours was not so reasonable. To any customers reading this here is a valuable money lesson I learned; if you need brain surgery find the best doctor you do not want to repeat that operation. This is true for my roof for years we kept spending money on top of money for cheap coatings not to mention my staff time up on the roof. This liquid epdm is not cheap but after my lesson do you really want a CHEAP roof product? I basically spend $1.28 per square foot with this product and over the past 5 years over $5.75 with the other products. Hope this helps those out there with the same situation we were in. Sorry guys I did promise pictures but we can’t seem to find them.

R. Patel

Owner
R&K Distributors



  • Testimonials

    • Mike H.

      My roof was in bad shape. I cleaned it and kept after it a few times a year. We bought the RV used, and there were signs of neglect when we bought it. It had been obviously sitting in the sun for an extended period of time without any care or maintenance. I was about to buy a sheet of EPDM and forego the labor intensive and very expensive task of replacing the sheet roof. Then I saw a video on Youtube for Liquid EPDM. So the research began. “This… Read more

    • Tom Pituch

      I was able to quickly find the 2 pictures I took after I patched the roof. I will continue to look for the before pictures, We have a flat roof with a channel down the middle that leads into a drain pipe system that has been our weak point area all along. Then we installed a sky light which was like adding gasoline to a fire. For years I was blaming the sky light that we installed. We even replaced portions of the sky light and sealed around it many… Read more

    • Bob & Sally H.

      The two pictures are the before and then after using your product Liquid Rubber. Very pleased with the way it turned out! And also the shipping sure came quickly. Have a great and safe day! Bob & Sally H.Yuma AZ

    • Rick M.

      The epdm rubber roof was easy to work with. I am very pleased after having a leaky roof that will be good for many years to come. Roof had mold on it so we first killed the mold with Clorox and water and scrubbed I down and then cleaned the roof with Dawn dish detergent. Attached are the before and after pictures. ThanksRick M.

    • Staff at EPDM Coatings,

      My 29, RV had a couple leaks, at the front where the aluminum and rubber roof came together under a molding, and under the radio antenna. I purchased the 5 gallon bucket. I mixed as directed, then poured mixed product into another clean bucket, scraped it clean, and mixed a few more minutes. After preparation, I applied the liquid rubber around all edges and roof fixtures, I poured small amounts out of the bucket onto the roof and distributed with squeegee or roller as needed, until product was gone and… Read more

  • Contact

    EPDM Coatings N.E Sales Office
    494 Bridgeport Ave Suite 101,
    PMB 342 Shelton CT 06484-4748
    Call: 610-298-1989, Fax: 702-977-2936
    Proud Distributor of Proguard Coatings
    Tel: 1-610-298-1989
    Email: [email protected]
Full Stocking Distributor of Proguard Coatings
Copyright © 2019 Buy Liquid Roof