Ronald S. (Virginia Beach, VA)

Posted on: March 25th, 2013 by Kellie

I ordered a gallon of Liquid Rubber last summer, and inquired if it could be spread with an adhesive applicator trowel; the sales person was not aware of this having been tried. I tried using a commercially available trowel with 4 sawtooth teeth per inch, and 0.135 inch notch depths, holding the trowel at about a 45 degree tilt. This worked great, and spread the liquid at exactly the recommended rate. The trowel is followed by a brush or roller to level the liquid.

My application is to repair the seams on an EPDM roof; the seams are weathering much faster than the roofing membrane. After wire brushing and vacuuming the areas to be repaired, the new coating is well adhered, smooth, and continuous, and, AFTER A YEAR AND A HALF THE ROOF LOOKS BRAND NEW! I just ordered two more gallons.



  • Testimonials

    • Rick M.

      The epdm rubber roof was easy to work with. I am very pleased after having a leaky roof that will be good for many years to come. Roof had mold on it so we first killed the mold with Clorox and water and scrubbed I down and then cleaned the roof with Dawn dish detergent. Attached are the before and after pictures. ThanksRick M.

    • Staff at EPDM Coatings,

      My 29, RV had a couple leaks, at the front where the aluminum and rubber roof came together under a molding, and under the radio antenna. I purchased the 5 gallon bucket. I mixed as directed, then poured mixed product into another clean bucket, scraped it clean, and mixed a few more minutes. After preparation, I applied the liquid rubber around all edges and roof fixtures, I poured small amounts out of the bucket onto the roof and distributed with squeegee or roller as needed, until product was gone and… Read more

    • Hello,

      My name is Jeremy Berkheimer and I purchased the liquid roof coating earlier this spring. I am attaching the before and after photos of my 38 sandpiper roof. This coating was awesome. It took some real cleaning before hand and a I got a bit of extra exercise spreading it but the finished product seems well worth it. Thanks!

    • Hi

      Please find attached before and after photos for my camper roof. I forgot to snap a pic of the before, so I had already started applying the Proflex primer when I took the picture. You can still see the condition of the roof though! Also, the after pic was after the newly coated roof endured it’s first rainfall.

    • Paul

      Hi Everyone, I completed my project and it was much easier than I thought, I wish I had done this years ago, and glad I chose this coating versus the other offerings out there. I will send you 2 more emails, this is the start of cleaning, next is primer, the third is the coating. Hope they are worth of a gift card. Thanks

  • Contact

    EPDM Coatings N.E Sales Office
    494 Bridgeport Ave Suite 101,
    PMB 342 Shelton CT 06484-4748
    Call: 610-298-1989, Fax: 702-977-2936
    Proud Distributor of Proguard Coatings
    Tel: 1-610-298-1989
    Email: info@epdmcoatings.com
Full Stocking Distributor of Proguard Coatings
Authorized Stocking Distributor of Proguard Coatings
Copyright © 2017 Buy Liquid Roof