Todd West

Posted on: March 22nd, 2013 by Kellie
Todd West_1

 Todd West_2

I have a 1996 25 foot camp trailer that has a rubber roof that needed coating. I did a lot of research before deciding on Liquid RV Roof. I already know that EPDM roofs are great and I was very happy when I found this product. The trailer roof had just a few very small holes and one small tear at the edge about 1-inch long. I washed the roof with a high pressure hot water washer and a great degreaser. Almost all of the old coating came off. I chose not to patch or reinforce any of the small holes. I opened and mixed the Liquid RV Roof product as per the instructions. With a friend to help me, we began to apply the thick mixture. It was a breeze to apply. Having a squeegee and roller is key. We applied on a nice cool day at about 70 degrees. We chose to do it in a location free from trees and debris. We applied about three gallons to the roof. (I bought 5 gallons…oops should have measured…not guessed) It only took about 1.5 hours to complete the application including doing the edges with a brush by hand. It took about 72 hours for the wrinkles to flatten. The small tear and pin holes were coated perfectly and sealed great.



  • Testimonials

    • Dave H.

      Overall, I am impressed with the results I obtained in using Liquid RV roof on my trailer. It was MUCH easier than replacing the membrane with new, and seems to have repaired my leaking roof, extending the life of my RV, as at some point, the cost of reroofing would exceed the RV’s value. Thanks in advance!

    • Mike H.

      My roof was in bad shape. I cleaned it and kept after it a few times a year. We bought the RV used, and there were signs of neglect when we bought it. It had been obviously sitting in the sun for an extended period of time without any care or maintenance. I was about to buy a sheet of EPDM and forego the labor intensive and very expensive task of replacing the sheet roof. Then I saw a video on Youtube for Liquid EPDM. So the research began. “This… Read more

    • Tom Pituch

      I was able to quickly find the 2 pictures I took after I patched the roof. I will continue to look for the before pictures, We have a flat roof with a channel down the middle that leads into a drain pipe system that has been our weak point area all along. Then we installed a sky light which was like adding gasoline to a fire. For years I was blaming the sky light that we installed. We even replaced portions of the sky light and sealed around it many… Read more

    • Bob & Sally H.

      The two pictures are the before and then after using your product Liquid Rubber. Very pleased with the way it turned out! And also the shipping sure came quickly. Have a great and safe day! Bob & Sally H.Yuma AZ

    • Rick M.

      The epdm rubber roof was easy to work with. I am very pleased after having a leaky roof that will be good for many years to come. Roof had mold on it so we first killed the mold with Clorox and water and scrubbed I down and then cleaned the roof with Dawn dish detergent. Attached are the before and after pictures. ThanksRick M.

  • Contact

    EPDM Coatings N.E Sales Office
    494 Bridgeport Ave Suite 101,
    PMB 342 Shelton CT 06484-4748
    Call: 610-298-1989, Fax: 702-977-2936
    Proud Distributor of Proguard Coatings
    Tel: 1-610-298-1989
    Email: [email protected]
Full Stocking Distributor of Proguard Coatings
Copyright © 2019 Buy Liquid Roof